Re: Flexible Headlight Stone Shield

[PLPKLT@xxxxxxx]

In a message dated 3/5/2004 11:24:22 AM Eastern Standard Time, microdoc@xxxxxxxxxxxxxxxx writes:

>  I think the material is made by 3M, and
> is used as a stone guard on cars and trucks too.  It seems 
> I can remember
> almost everything about it except who sells it.


I'm not sure who sells it either but I watched the guy put it on several bikes.  It was Fantastic to watch him.  he really worked it on the curved lense of a Yamama FJR...  He made it look easy but clearly it was not.  he went very slowly and applied quite a bit of pressure and worked the bubbles out as he went.  He was an artist at it, of course he had probably done hundreds of them.   He trimmed it after he applie it with a very sharp exacto knife and made sure he left enough on at the edge to slightly wrap around the edge of the lense so it wouldn't end right on the edge which he said would allow it to lift off.

Good luck at installation, I'm sure it will go ok as long as you apply sufficient adult beverages (after installation)..
paige

------------------------------

End of oilheads-digest V1 #123
******************************