Re: Lets get back to oilheads... throttle body question

[Robert Silas <robert.silas@xxxxxxxxxxxx>]

Hello All,
I am looking for the following parts for an 1994 R1100RS:
1.) Front wheel axel
2.) Front shroud (reflector housing) 
3.) Front shroud supporting bracket.
4.) Rear frame.
5.) Rear tool and light supporting housing
6.) Front wheel
I would have a chance to rebuild a '94 RS.
Any answer or suggestion where to find some of these used parts will be greatly appreciated.

Bob Silas 
 
  ----- Original Message ----- 
  From: John Van Deren 
  To: oilheads@xxxxxxxxx 
  Sent: Tuesday, September 06, 2005 6:29 AM
  Subject: Re: Lets get back to oilheads... throttle body question


  Hi Clive,
  I've read that TPS should be about .370, but it's good to hear that 
  others are lower too.  Thanks,

  John Van Deren
  Montpelier, VT


  Clive Liddell wrote:

  >John,
  >You say: "I did find the existing TPS to be a bit low at .340 but I'm not
  >going to change anything until the o-ring is installed and another balance
  >attempted"
  >
  >My (non-cat) R1100RT has been around 335-340 mV since new and I have no
  >complaints...
  >Regards
  >Clive Liddell
  >Pietermaritzburg, South Africa
  >'96 R850R ~79k.km
  >'01 R1100RT ~60k.km

------------------------------