Oilhead cylinder torque

["Eckhard Grohe" <egrohe@xxxxxxxxxx>]

Fellows:

This snippet below indicates to me that we should be torquing to 20 Nm and
doing 1 pass over all of the nuts turning 90 degs. and a second pass over
all of the nuts turning another 90 degrees.  That is different from torquing
180 degrees in 1 pass.  If we accept that 180 degree logic we could also
accept torquing to 20 Nm and do the 180 deg. right away before moving to the
next bolt.
'snip'

>
>   1. Tighten cylinder head nuts crosswise
>   1.1 Tighten all nuts to 20 Nm
>   1.2 Tighten all nuts to correct angle 90 degress
>   1.3 Tighten all nuts to correct angle 90 degress
>           2. M10 screw 40 Nm
>   3. M6 screw 9 Nm
>
'snip'

Eckhard Grohe
Chateauguay, Qc

------------------------------