Re: cylinder studs: torque or length?

[Mick <bmwmick@xxxxxxxxxxx>]

At 08:38 AM 4/2/2006 -0700, jmerlinw wrote:
>Rod:
>
>Thanks for the input This is the confusing part. Yu are (accurately)
>referring to the torque on the head NUTS (see Rod's picture at:
>http://www.pbase.com/rodneff/image/41825708)
>
>My question is the torque on the STUDS themselves (if any) - I have had two
>people say that you JUST go by the length of the studs above the cylinder
>(152.5mm and 132mm).

Correct,
   There is no torque spec for the studs themselves.
Mick
Tucson

------------------------------

End of oilheads-digest V3 #47
*****************************