[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: dirve shaft phasing

The two universal joints must be mirror images, or as close as possible.  I
believe that due to the splines they can be slightly "out".
Regards
Clive Liddell
Pietermaritzburg
South Africa
R850R
R1100RT

-----Original Message-----
From: owner-oilheads@xxxxxxxxx [mailto:owner-oilheads@xxxxxxxxx] On Behalf
Of plpklt@xxxxxxx
Sent: 06 March 2007 16:19
To: oilheads@xxxxxxxxx
Subject: dirve shaft phasing

Can someone tell me what the correct way to phase the drive shaft?  I seem
to remember you pahse them 90 degrees out to each other to cancel out the
motion of the universal joints,  Is this correct?